Forkliftaction.com

DISCUSSION FORUMS : Forkliftaction.communicate

My forum profile

Printable version

Discussion Forums Home

Forum:

Mechanical Troubleshooting

Brand: B/t Prime Mover - Model: RTX35

Number of messages: 5

START MESSAGE:

yomar_p
Florida, United States

Have a reach truck that code E 131. Model RTX35, S/N RTX353148002

Posted 8 Jan 2008 09:20 AM

Report this message

REPLIES:

Sort replies by

carl_v
Pennsylvania, United States

E131 - Security Relay Error 1 (Internal to the A5 Card)*
*Parameter 13 (BDI Parameter Adjustment may have to be performed)
This what is stated in the RTX manual
Could email you BDI adjust procedure.

Posted 22 Jan 2008 05:06 AM

Report this message

lifterman
Iowa, United States

The number one cause of this problem is running the battery dead over and over and to continue to use the truck with the dead battery. If your battery is old and worn out then adjust parameter 13 to properly reflect the actual battery voltage(see service manual). This will decrement the bdi slower or faster depending on which way you go to better reflect actual battery voltage. There are 2 relays in the bottom of the card. Power goes through one to get to the other. They have small tips on them that can be cleaned up and will buy you some time until it sticks again. A new battery or keeping it charged may get you good life out of the card after you cleaned the tips. If you can't get rid of the error or it comes back after a few days you may need a new A5 card. If you install a new A5 make sure the parameters are setup correctly. There are tables in the service manual that shows how to set them.

Posted 5 Feb 2008 03:11 PM

Report this message

NissanFixer
Michigan, United States

Take the A5 logic card out and remove the cover. There are two small relay's on the main board. Remove plastic cover and clean tips with sandpaper. Truck will now run normally.

Posted 5 Nov 2008 02:48 AM

Report this message

JSVT
California, United States

I have the same error code, but I cannot identify the A5 logic card, can I get also the BDI Parameter Adjustment procedure? thank you very much.

Posted 13 Nov 2008 03:03 AM

Report this message

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

FORUM GLOSSARY

Click for description.

FORUM

DISCUSSION

MESSAGES

NICKNAME

SIGNATURE

FORUMS

Discuss: Industry News & Whispers

Discuss: Conferences, trade shows & other events

Discuss: Mechanical Troubleshooting

Discuss: Technical arena. Did you know? Who knows?

Discuss: Machines. Forklifts, stackers, telehandlers, container handlers and reach stackers

Discuss: Business issues

Discuss: Safety, training & legislation

Discuss: Fun at work