Forkliftaction.com

DISCUSSION FORUMS : Forkliftaction.communicate

My forum profile

Printable version

Discussion Forums Home

Forum:

Technical arena

Discussion:

Raymond easi reach

Number of messages: 4

START MESSAGE:

SirWorkalot
Tennessee, United States

code 66,any advice on where to start looking for this one,comes up intermittently,can reset,

Posted 8 Jul 2009 05:18 AM

Report this message

REPLIES:

Sort replies by

martin_w
British Columbia, Canada

No such thing as a 66, probably a 6G. Lift motor temp sensor out of range. You can run test A09 if you have the superword, however you probably have a failed sensor. Disconnect it from the system card at JPS6, resistance across it should be about 2000ohms at room temp, rising a little if you GENTLY warm it. I bet a wire is broken off at the motor. . . .

Martin

Posted 8 Jul 2009 02:06 PM

Report this message

martin_w
British Columbia, Canada

Oh, I reread your post, you said intermittantly. Perhaps the motor is just overheating??

Martin

Posted 8 Jul 2009 02:08 PM

Report this message

raymondguy
Alberta, Canada

the sensors on the lift motor and on the heat sink are interchangable with drive motor sensor, swap them and see if the code changes, I have replaced lots of temp sensors. also check the 2 wires that follow the motor cables, pull hard on them, the wires will break inside and the outer cover will allow it to go open intermittanly

Posted 10 Jul 2009 10:10 AM

Report this message

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

FORUM GLOSSARY

Click for description.

FORUM

DISCUSSION

MESSAGES

NICKNAME

SIGNATURE

FORUMS

Discuss: Industry News & Whispers

Discuss: Conferences, trade shows & other events

Discuss: Mechanical Troubleshooting

Discuss: Technical arena. Did you know? Who knows?

Discuss: Machines. Forklifts, stackers, telehandlers, container handlers and reach stackers

Discuss: Business issues

Discuss: Safety, training & legislation

Discuss: Fun at work