Forkliftaction.com

DISCUSSION FORUMS : Forkliftaction.communicate

My forum profile

Printable version

Discussion Forums Home

Forum:

Technical arena

Discussion:

e-3000 ac speed control

Number of messages: 3

START MESSAGE:

proshadetree
Tennessee, United States

Not looked at this truck yet but can you slow these down so operator cant change through dash?Also has anyone had pump failures with this unit?

-------------------------
"Work leads to profit, mere talk leads to poverty"

Posted 10 Nov 2009 01:27 AM

Report this message

REPLIES:

Sort replies by

edward_t
North Carolina, United States

you are far more likely to have a clogged up relief valve in the main hydraulic control valve or motor turning too slow than a pump problem but there have been some. (not many) be sure you have an A/C clamp on amp gage when you go to check it out, to insure the amps are good, as well as the pressure.
As I remember it, with the laptop (or the D-R-S switch), you can either set all the setups for a slower speed, or you can set the unit up as an EE unit and that will prevent higher speed, and higher amps on a ramp, and prevent the changing of the speed with the dash

-------------------------
webhome = forktechs.com

Posted 10 Nov 2009 08:08 AM

Report this message

proshadetree
Tennessee, United States

Thank you Ed these units rip the splines off the pump.Customer said it was rusty on the splines

Posted 10 Nov 2009 10:03 AM

Report this message

Forkliftaction.com accepts no responsibility for forum content and requires forum participants to adhere to the rules. Click here for more information.

FORUM GLOSSARY

Click for description.

FORUM

DISCUSSION

MESSAGES

NICKNAME

SIGNATURE

FORUMS

Discuss: Industry News & Whispers

Discuss: Conferences, trade shows & other events

Discuss: Mechanical Troubleshooting

Discuss: Technical arena. Did you know? Who knows?

Discuss: Machines. Forklifts, stackers, telehandlers, container handlers and reach stackers

Discuss: Business issues

Discuss: Safety, training & legislation

Discuss: Fun at work